To 2 Wheel Creations

DIVERISTY---------INNOVATION ----------QUALITY----------SERVICE

What makes 2 Wheel Creations different from other companies, it’s our diversity. Most companies offer one or two services, such as repair and/or service, 2 Wheel Creations offers both as well as complete restoration.  I offer full tear-down of your bike and/or ATV, to include engine repair, full powder coating and restoration of the machine.

Innovation means going beyond the norm. I offer custom powder coating with inlay graphics and ceramic CermaKrome. I provide 100’s of different colors and high temp powders to meet the demanding needs of today’s engines. From frames to gas tanks and engines, I can powder coat in exciting colors and then clear coat them for added protection against the elements.

Quality means that I guarantee my work every time I handle your machine. If it isn’t right the first time I will work until I can produce a product to your satisfaction. I attempt to keep my prices as low as possible for you and for myself.  If it isn’t right I will make sure that it is.

Service and Quality go hand in hand for myself personally and my business. I work to produce the finest quality you expect to the best of my ability; however I am not God and can’t make a rose out of a lump of coal.  I will however get it close.

My Motto is  Under Promise and Over Perform

Established in 2005 to design and manufacturer performance intake manifolds for the Yamaha RoadStar, the company has continued to expand and add additional products and services. In 2006 I added powder coating to offer customer a choice in finishes on the intakes and invested in a large oven and spray booth.  In 2009 I purchased a Land & Sea Motorcycle/ATV Dyno along with a 16 ft. dual axle trailer for attending motorcycle event. The Dyno provides HP, torque and air to fuel reading for expert tuning of both fuel injected and carbureted motorcycle and ATV’s.  In April 2009 I open my new location in the old automatic car wash bay at the car wash located along route 403 in the Ben’s Creek area of Johnstown. The 1200 Sq. Ft. houses my 2 lifts, powder coating booth and oven along with my stripping tank, buffing equipment and shop tools.

In 2011 I added ceramic coating of cermakrome, a high temperature coating that looks like polished stainless steel. A vibrating finisher was also added to do polishing.  In 2012 I hope to bring additional services to meet the growing customer demands for innovative products and services.